VCS VIP 1000 User's Guide download pdf (Page 53)

Chapter 6 Configuring the Sender

VIP 1000 53

Alarm connections

You can select a number of options for the response of the VIP to an alarm. In

case of an alarm, the VIP can establish a connection to a predefined IP address

(VCS hardware receiver or PC with receiver software) automatically. You can

enter up to ten IP addresses which will be selected in sequence by the unit until

a connection is established.

Note

Sender and receiver must share the same subnet for connection set-up

(see page 62).

Connect on alarm:

Select On for the VIP to establish a connection automatically to a specified IP

address in the event of an alarm.

With the setting Follows input 1, the VIP holds the automatically set up

connection to a remote location as long as an alarm signal is present at the alarm

input 1.

Sending encoder:

Here you can select the encoder that is to send the data for the alarm connection

to the specified IP address dependent on the environment used (network

configuration). In doing so, consider the settings used for the MPEG-2 and

MPEG-4 encoder (refer to page 42).

Note

If the MPEG-4 encoder is chosen Stream 1 will be transmitted.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 125 126

No comments

VCS VIP 1000 User's Guide Page 53