VCS VIP 10 User's Guide download pdf (Page 106)

Maintenance and Upgrades Chapter 12

106 VIP 10

can likewise result in the unit no longer being addressable, requiring it to be

replaced.

Note

After a reset, the unit can only be addressed via the factory default IP

address. The IP address can be changed as described in the chapter

entitled Installation (see page 22).

– If necessary, back up the current settings using the Download button on the

configuration page entitled Firmware and configuration upload (see page

66 for sender and page 83 for receiver).

– Use a pointed object to press the reset button which is found below the USB

interface (see page 16) until the „operating status“ LED blinks red. All settings

will revert to their defaults.

– Change the IP address of the unit as necessary.

– Configure the unit to meet your requirements.

Repairs

Warning!

Never open the casing of the VIP device. The unit does not contain parts

that you can repair or replace.

Ensure that maintenance or repair work is performed only by qualified personnel,

or contact your VCS dealer service center.

Transfer and disposal

The VIP should only be passed on together with this manual.

The unit and its power supply contain environmentally hazardous materials that

must be disposed of according to law.

Defective or superfluous units and parts should be disposed of professionally or

taken to your local collection point for hazardous materials.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 121 122

No comments

VCS VIP 10 User's Guide Page 106